Watchguard V2 Spécifications télécharger pdf (Page 45)

Wireless Siren Auto Test

Use this mode to test that the wireless siren is operating correctly

WIRELESS SIREN AUTO TEST

Set dipswitches 1 and 5 to on.

The strobe on the siren will flash every 5 seconds, and the

main unit will beep out the signal strength every 5 seconds.

The beeps range from 1-10. The minimum acceptable

strength is 3.

Note: if the 3 beeps are not achieved, relocate the siren

slightly. If the 3 beeps are still not achieved then relocate

the siren closer to the main unit.

Wireless Siren Disable Use this mode when the Wireless Outside Siren is not required.

IMPORTANT! If you do not carry out this step, the system will think the siren has failed and

will send a supervision failure message to the Monitoring Centre, 24 hours after system

installation.

WIRELESS SIREN DISABLE

Set dipswitches 1 and 6 to on.

Press either ADD or DELETE

ADD ENABLE Wireless Siren

DELETE DISABLE Wireless Siren

The unit will beep once to confirm either Enable or

Disable of wireless siren.

ADD

DELETE

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Pas de commentaire

Watchguard V2 Spécifications Page 45